Process Check (SNMP)
Configure the following for the SNMP Process Check component:
- . Enter a unique name for the component.
- . Enter additional information about the component.
- . Click to select this check box if the component is critical.
: Components specified as critical cause the application to go into a down state when the component is out of threshold. Non-critical components cause the application to go into a warning state. For more information on application states, see Working with application states.
- . Select a time (in minutes or hours) you want APM to wait between polls.
- . Enter the name of the process you would like to monitor. You can type the process name or click browse () to open the device browser and select the specific device and process.
- . Select this option to put the application in a down state if the process is not running.
- . Enter the length of time APM attempts to connect to the selected device. When the time you enter is exceeded without connecting, a timeout occurs and APM stops trying to connect to the device. This is considered a failed connection.
- . Enter the number of times APM attempts to send the command before the device is considered down.