Enabling the IP SLAs Responder on the Destination Device

To enable the IP SLAs Responder on the destination device:

Note: The following instructions are example configuration instructions for configuring an IP SLA destination device. For additional configuration information, see the Cisco IOS IP SLAs Configuration Guide, Release 12.4.

1. In the Cisco Command Line Interface (CLI) on the destination device, enable the privileged EXEC mode, type:
   Router> enable
   Type your password if prompted.
2. Start the global configuration mode, type:
   Router# configure terminal
3. Enable the IP SLA responder, type:
   Router(config)# ip sla responder
4. Repeat steps 1 through 3 for each IP SLA device (responder) for which you want to monitor VoIP network performance.
5. Exit the global configuration mode and return to the privileged EXEC mode, type:
   Router(config)# exit

See Also Configuring Cisco devices for IP SLA VoIP UDP Jitter operations