Using SNMP Smart Scan
To use SNMP Smart Scan, configure these settings:
- . Enter the IP addresses that indicate where you want to start the network discovery scan. The discovery engine reads SNMP data from these devices and continues to scan the network for additional devices based on the SNMP responses from the seed devices.
- . Click to enter a new seed address for the discovery scan.
- . Select a seed address to change.
- . Select a seed address to delete.
- . Enter an integer value that defines how deep discovery should scan to find network devices. This sets the levels of your network that you want to scan. With a value of 1, the scan discovers and maps your top-level network and any sub-networks of that top-level. To discover a sub-network within that sub-network, you must enter a scan depth of 2 or greater. The default value of 2 means that the scan discovers and maps the top-level network and two sub-network levels.