Using the Pager Action
The Pager Action sends a user-specified message to a pager.
To configure a Pager Action:
- Go to the Action Library:
- From the web interface, click . The GO menu appears.
- If the WhatsUp section is not visible, click . The WhatsUp section of the GO menu appears.
- Select . The Action Library appears.
- or -
- From the main menu bar of the console, select . The Action Library appears.
- In the Action Library, do one of the following:
- Enter or select the appropriate information in the following fields.
- . Enter an identifying name for this pager action.
- . Enter a short description of the action. This is displayed along with the Names in the Action Library.
- . Enter the pager number to dial. Your service provider can provide you with this number.
- . If required, enter the pager password here. This is a password that is required to log in to some paging services.
- . Select either , or one of the setups.
- Click to further define your selection. Modem Setup is used specifically to support different service providers in case you use more than one provider for sending your pager notifications. There could also be times you want to change your settings to meet a specific service provider's requirements for a specific notification (for example: a lower baud rate). To do this, you can set up an alternate Modem Setup and associate this to the notification instead of using your Primary setting.
: Changing the Port Settings for the desired Modem Setup will affect ALL uses of that setting.
- . Select the type of protocol used by your pager service.
- . Enter the pager identification number.
- . Enter a text message plus any of the percent variable codes used to deliver WhatsUp Gold information with the page.
- Click to save changes.