Configuring Protocol Settings

Use the Protocol Settings/Credentials dialog to configure the protocol credentials (for ICMP, SNMPv1-v3, SSH, or VmWare) that you want to use for network discovery.

• SNMPv1 discovery requires the SNMP read community information, timeout settings, and retry counts.
• SNMPv2 discovery requires the SNMP read community information, timeout settings, and retry counts.
• SNMPv3 discovery requires the associated Username, timeout settings and retry counts. Optionally, you can select to use Authentication and Encryption.
• ICMP discovery requires the timeout settings and retry counts.
• SSH discovery requires the User Name, Password, and Port used to attempt an SSH connection.
• VmWare discovery requires the User Name, Password, and Port used to attempt a VmWare (VIM) connection.
• Note: You can only edit the default ICMP settings; you cannot create a new set of ICMP settings.

To configure Protocol Settings:

• From the main menu of the WhatsConnected console,select Configure > Protocol Settings/Credentials. The Protocol Settings dialog appears.

To create a new set of protocol credentials:

1. Click New.
2. Select the type of Protocol settings that you would like to create, then click OK. The protocol properties dialog appears.
3. Enter the appropriate protocol settings in the protocol editor.

To edit protocol settings:

1. Select a set of protocol credentials, then click Edit. The protocol properties dialog appears.
2. Enter the settings you want to modify in the protocol editor.

To copy protocol settings:

1. Select a set of protocol credentials, then click Edit. The protocol properties dialog appears.
2. Make any needed changes, then click OK.

To delete a set of protocol credentials:

1. Select a set of protocol credentials, then click Delete. The protocol setting is deleted from the list.

Click OK to save changes.