NetFlow Port

How to get here

Use this dialog to create a new pattern for NetFlow to use to interpret traffic on your network.

Enter or select the appropriate information in the following fields.

• Port. The port number; enter a port number if applicable.
• Application. Enter a name for the traffic that matches the port and protocols selected. This name is used by all application reports (such as Top Sender Applications and Top Receiver Applications).
• Do not monitor this port. If selected, data about traffic transmitted over this port is not classified by application.
• Monitor the following protocols on this port.
  • TCP. Select this option to classify traffic that uses the TCP protocol over this port as the application listed in Application.
  • UDP. Select this option to classify traffic that uses the UDP protocol over this port as the application listed in Application.
  • SCTP. Select this option to classify traffic that uses the SCTP protocol over this port as the application listed in Application.
  • DCCP. Select this option to classify traffic that uses the DCCP protocol over this port as the application listed in Application.

Note: You can only create one pattern for each port number. As such, you cannot categorize TCP data over a port as a different application than UDP data over the same port.

Click OK to save changes.