About the Interface Utilization report

This monitor report displays the percent utilization for device interfaces.

Device Report:

Group Report:

Interface Utilization report for a device

Interface Utilization report for a group

Monitor report body for device reports

When a device is selected, the percent utilization for the currently selected interface displays. Each point on the graph corresponds with an entry in the graph data table below. In Octets are graphed with a red line, while Out Octets are graphed using blue.

When multiple interfaces are present in the selected device, change the selected interface using the Interface menu.

Changing how the chart looks

Click the Chart Properties button to change how the report chart is displayed.

Split Second Graphs - Real-Time Interface Utilization for devices

Under the main report graph is a Split Second Graph that displays real-time interface utilization data.

Note: Split Second Graphs are not available in WhatsUp Gold Standard Edition.

Note: Split Second Graphs are not available in VMware host reports.

Note: When viewing information for devices running Microsoft Windows, information gathered via WMI is displayed in real time. Information gathered by SNMP, however, may reflect a delay of one minute or more. This delay is caused by a limitation in how often Microsoft Windows updates SNMP values.

Below the Split Second Graph, the Summary report displays the average interface utilization collected during the time period:

Note: Values displayed in the graph are the average values for the selected time period. Values displayed in the summary are the minimum, maximum, and average values for the selected time period. If raw polling data has been averaged into hourly or daily summarized data, the values for min and average, or maximum and average can be different. In some cases, they may be very different if there was a period of time when polled values were much higher or lower than normal.

You can verify your report rollup settings on the WhatsUp Gold console via Program Options > Report Data.

Monitor report body for groups

Below the date/time picker is a table showing interface utilization across the current group for the selected time period.

Split Second Graphs in group reports

To see a real-time graph for the utilization of a device, hover over the interface description in the Description column.

Navigation

Change to another device monitor report by selecting a different report button.

Viewing Properties

To view the properties of the current group or device, click Properties in the toolbar.

See Also

Network monitor reports

Learning about network monitors

About the Interface Traffic report

About the Ping Availability report

About the Ping Response Time report

About the Interface Discards report

About the Interface Errors report