Adding and editing a Pager Action
To add or edit an Email action:
- Click the tab, then click .
- Click and select from the list to create a new Pager action. Click .
- or -
Select the action you want to change from the list of current actions, and then click . - Type or select the appropriate information in the following fields.
- . Type a name for the action. This name displays in the Action Library.
- . Type a short description. This description displays next to the action in the Action Library.
- . Type the pager number to dial. Your service provider can provide you with this number.
- . If required, type the pager password here. This is a password that is required to log in to some paging services.
- . Select either Primary, or one of the Alternate setups.
- . Click to further define your modem setup selection. Modem Setup is used specifically to support different service providers in case you use more than one provider for sending your pager notifications. There could also be times you want to change your settings to meet a specific service provider's requirements for a specific notification (for example: a lower baud rate). To do this, you can set up an alternate Modem Setup and associate this to the notification instead of using your Primary setting.
: Changing the Port Settings for the desired Modem Setup affects ALL uses of that setting.
- . Select the type of protocol used by your pager service.
- . Type the pager identification number.
- . Type a text message plus any of the percent variable codes used to deliver WhatsUp Gold information with the page.
- Click to save your changes.
: To check the status of an action, or to cancel an action, on the console go to Tools > Running Actions.